Environmental Concerns - Zanussi ZWN 7100 L User Manual

35°
The other end of the inlet hose which con-
nects to the appliance can be turned as
showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap. Set the hose
correctly by loosening the ring nut. After posi-
tioning the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:

Environmental concerns

The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
24
45°
Hooked over the
edge of a sink us-
ing the plastic
hose guide.
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside di-
ameter of the drain hose. The drain hose must
not be kinked.
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
please contact your local council, your
household waste disposal service or the shop
where you purchased the product.
www.zanussi.com