Zanussi ZWI 71201 WA User Manual
Front-loading washing machine
Hide thumbs
Also See for ZWI 71201 WA:
- User manual (32 pages) ,
- User manual (32 pages) ,
- User manual (25 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWI 71201 WA
Summary of Contents for Zanussi ZWI 71201 WA
- Page 1 User manual Washing Machine ZWI 71201 WA ZWI 71401 WA...
-
Page 2: Table Of Contents
• After having installed the appliance, check that it is not drum before using. standing on the inlet and drain hose and the worktop is • Any objects such as coins, safety pins, nails, screws, stones or any other hard, sharp material can cause ex- www.zanussi.com... - Page 3 • Never pull the power supply cable to remove the plug from the socket; always take hold of the plug itself. • Never use the appliance if the power supply cable, the control panel, the working surface or the base are dam- www.zanussi.com...
-
Page 4: Product Description
Control panel On the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages. www.zanussi.com... - Page 5 Start Pause Quick Wash This button allows you to start or to interrupt the selected A very short cycle for lightly soiled items or for laundry programme. which needs only freshening up. We recommend you to reduce the fabrics loading. www.zanussi.com...
-
Page 6: Delay Start
Maximum spin speed at 1200 rpm for model ZWI71201WA QUICK WASH Maximum spin speed at 1400 rpm for model ZWI71401WA PREWASH Max. load 7 kg - Reduced load 3 kg EASY IRON White and coloured cotton (normally soiled items). EXTRA RINSE www.zanussi.com... - Page 7 Note: A single or bulky item may cause imbalance. If the appliance doesn’t perform the final spin phase, add more items, redis- tribute the load manually and then select the spinning pro- gramme. www.zanussi.com...
- Page 8 At the end of the soak (after having emptied out the water) you can select the washing programme (first turn the programme selector dial , then to the programme and press the button 5). www.zanussi.com...
- Page 9 2) If you select the Super Quick option by pressing button 3, we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results. 3) Max. load with Easy iron option 1.5 kg 4) If using liquid detergents, a programme without PREWASH must be selected. www.zanussi.com...
-
Page 10: Helpful Hints And Tips
Lipstick: moisten with acetone as above, then treat stains water used. with methylated spirits. Treat any residual marks with Follow the product manufacturers’ instructions on quanti- bleach. ties to use. Use less detergent if: 1) do not use acetone on artificial silk www.zanussi.com... -
Page 11: First Use
There is a risk of pulling the door handle water leakage or damage outwards. Place the laun- to the laundry. dry in the drum, one item at a time, shaking them out as much as possible. Close the door. www.zanussi.com... - Page 12 The Set the washing machine to PAUSE by pressing but- relevant pilot light illuminates. ton 7. Press button 8 once. On the display will appear Press button 7 again to start the programme. www.zanussi.com...
-
Page 13: Care And Cleaning
This will help to prevent the formation of lime de- any cleaning or maintenance work. posits. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the ma- www.zanussi.com... -
Page 14: Cleaning Dispenser Drawer
• the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details). www.zanussi.com... - Page 15 The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out; • clean the pump if necessary as previously described; www.zanussi.com...
-
Page 16: What To Do If
The filter in the inlet hose or the inlet valve filter are blocked. • Clean the water inlet filters. (See "Cleaning the water inlet filters" for more details). The door is not properly closed. • Close the door firmly. www.zanussi.com... - Page 17 • Wait the end of washing cycle. The door lock has not been released. The door will not open: • Wait until the pilot light 9 goes off. There is water in the drum. • Select drain or spin programme to empty out the water. www.zanussi.com...
-
Page 18: Technical Data
Prod. No..Ser. No..Technical data Dimensions Width 60 cm Height 85 cm Depth 54 cm Electrical connection Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. www.zanussi.com... -
Page 19: Consumption Values
After removing all the Remove the power supply packaging, carefully lay cable and the hoses from machine on it's back to re- the hose holders on the move the polystyrene base rear of the appliance. from the bottom. www.zanussi.com... - Page 20 MUST be level and stable. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a span- ner. 35° 45° www.zanussi.com...
- Page 21 “U” Firstly form a hook in the end of the drain hose using piece”. Just push the hose the “U” piece” supplied. firmly in to the standpipe. 2. Onto a sink outlet spigot. “U” piece supplied Loop www.zanussi.com...
-
Page 22: Building In
The appliance is supplied with a 13 amp plug fitted. Building in This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. www.zanussi.com... -
Page 23: Preparation/Assembly Of Door
The machine is originally prearranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. B). www.zanussi.com... -
Page 24: Front View
(4) on the appliance strips of timber are glued and screwed to the underside (see picture D). of the base (see Fig. F). Graphic G 600-605 Front edge Top view Caution! Do not remove the screw 8! www.zanussi.com... -
Page 25: Environment Concerns
Packaging materials • Measure out detergent according to the water hard- The materials marked with the symbol are recyclable. ness, the degree of soiling and the quantity of laundry >PE<=polyethylene being washed. >PS<=polystyrene >PP<=polypropylene www.zanussi.com... - Page 26 www.zanussi.com...
- Page 27 www.zanussi.com...
- Page 28 www.zanussi.com/shop...