Registering Menu Settings - Sony UP-991AD Instructions For Use Manual

6
Press the menu lever.
The unit enters the mode in which you can select
the printing direction.
"SIDE:OFF," which is the factory setting, is
displayed on the LCD. "SIDE:OFF" is the currently
selected setting.
In this menu operation, you will change the setting
to "SIDE:ON."
7
Display "SIDE : ON" by turning the menu lever up
or down, then press the menu lever.
"SIDE:ON" is registered as the printing direction.
"-SIDE" reappears on the LCD.
Note
If about 20 seconds elapse without making any
menu lever operation after you have displayed the
menu item or setting, the display returns to
"READY" on the LCD and the unit exits the menu
mode. In such a case, the setting of "-SIDE" will
not change.
To cancel the setting
1
Return the LCD display to "SIDE" by turning the
menu lever to the left.
26
Adjustments and Settings Using the Menu
To continue menu operations
Make settings by repeating steps 3 to 7.
To end menu operation
1
After step 7, exit the menu mode by turning the
menu lever twice to the left.

Registering Menu Settings

You can store up to three sets of menu settings, which
you can load at any time.
The unit retains these settings even if you turn off the
power.
Note
When you use the unit for the first time after you
purchase it, factory settings are registered in all three of
the stored selections.
Registering new settings
1
Make all of the required settings.
2
Display "CONFIG" by turning the menu lever up or
down.
3
Display "-SAVE" by turning the menu lever to the
right and up or down, and then press the menu lever.
4
By turning the menu lever up or down, display the
number to which you want to register the settings,
and then press the menu lever again.
The settings made in step 1 are registered in the
number displayed in this step.
Loading the desired settings
You can load the desired settings.
1
Confirm that "READY" is displayed on the LCD,
and press the menu lever.
2
Display "CONFIG" by turning the menu lever up or
down.
3
Display "-LOAD" by turning the menu lever to the
right and up or down, then press the menu lever
again.
4
By turning the menu lever up or down, display the
number in which the settings you want to load are
registered, then press the menu lever again.
The settings registered in the number displayed in
this step are loaded.