Mercedes-Benz 2006 C 55 AMG Operator's Manual page 407

Practical hints
Flat tire
The jack take-up brackets are located
directly behind the front wheel housings
and in front of the rear wheel housings.
1 Take-up bracket
2 Jack
Place jack 2 on firm ground.
Position jack 2 under take-up
bracket 1 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
406
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.
Warning!
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
Never start the engine when the vehicle
is raised.
Never lie down under the raised vehicle.
Removing the wheel
1 Alignment bolt
Unscrew upper-most wheel bolt and
remove.
G Replace this wheel bolt with alignment
bolt 1 supplied in the tool kit.
Remove the remaining bolts.
!
Do not place wheel bolts in sand or dirt.
This could result in damage to the bolts
and wheel hub threads.
Remove the wheel.