Table of Contents
Advertisement
Install the heatsink.
6.
Install the air baffle
7.
Install the access panel
8.
Slide the server into the rack.
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server.
12.
DIMMs
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
IMPORTANT:
these two types causes the server to halt during BIOS initialization.
To identify the DIMMs installed in the server, see "DIMM slot locations (on page 77)."
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
("Air
baffle" on page 29).
("Access
panel" on page 29).
To reduce the risk of personal injury, electric shock, or damage to the equipment,
This server does not support mixing RDIMMs and UDIMMs. Attempting to mix
Removal and replacement procedures 55
Advertisement
Table of Contents
