Table of Contents
Advertisement
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
Disconnect any external cables that are connected to the expansion board.
5.
Disconnect any internal cables that are connected to the expansion board.
6.
Release the full-length expansion board retainer, and then remove the PCIe riser cage.
7.
Remove the full-length expansion board.
8.
To replace the component, reverse the removal procedure.
Heatsink
WARNING:
internal system components to cool before touching them.
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
heatsink is removed from the processor after it has been installed.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
("Access
panel" on page 29).
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To reduce the risk of personal injury, electric shock, or damage to the equipment,
The heatsink thermal interface media is not reusable and must be replaced if the
Removal and replacement procedures 48
Advertisement
Table of Contents
