Table of Contents
Advertisement
If the drives are migrated to different drive positions or there are volumes present in the recovery server,
a 1724 POST message appears, stating that logical drive configuration has been updated
automatically.
Expansion slot blanks
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
Disconnect any external cables that are connected to the expansion board.
5.
Disconnect any internal cables that are connected to the expansion board.
6.
Remove the PCIe riser cage
7.
Remove the expansion slot blank.
8.
To replace the component, reverse the removal procedure.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
For proper cooling, do not operate the server without the access panel, baffles,
("Access
panel" on page 29).
("PCIe riser cage
(primary)" on page 31).
Removal and replacement procedures 46
Advertisement
Table of Contents
