D-Link DWL-7700AP User Manual page 34

DWL-7700AP User's Manual
Home > Advanced Settings > Performance (continued)
Fragment Length:
RTS Length:
Transmit Power:
IGMP Snooping:
Advance Data Rate Settings:
*Maximum wireless signal rate derived from IEEE Standard 80.11a and 80.11g specifications. Actual data throughput will vary. Network
conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead lower
actual data throughput rate.
D-Link Systems, Inc.
(Delivery Traffic Indication Message) - Select a setting between 1 and 55.
DTIM:
1 is the default setting. DTIM is a countdown informing clients of the next
window for listening to broadcast and multicast messages.
The fragmentation threshold, which is specified in bytes, determines whether
packets will be fragmented. Packets exceeding the 346 byte setting will be
fragmented before transmission. 346 is the default setting
This value should remain at its default setting of 346. If you encounter
inconsistent data flow, only minor modifications to the value range between
56 and 346 are recommended
Choose full, half (-3dB), quarter (-6dB), eighth (-9dB), minimum power.
Radio: Select ON or OFF.
WMM: (Wi-Fi Multimedia) Improves the user experience for audio, video, and
voice applications over a Wi-Fi network. This feature is enabled by default,
uncheck to disable.
Internet Group Management Protocol (IGMP) snooping allows the AP to
recognize IGMP queries and reports sent between routers and an IGMP host
(wireless STA). When enabled IGMP snooping, the AP will forward multicast
packets to IGMP host based on IGMP messages passing through the AP.
Specify the data rates at which the DWL-7700AP should transmit signals.
For 80.11a, choose from 9Mbps, 18Mbps, 36Mbps, 48mbps, and 54Bbps.
For 80.11b, choose from 5.5Mbps, 11Mbps. For 80.11g, choose from
9Mbps, 18Mbps, 36Mbps, 48Mbps, and 54Mbps. For 80.11b/g, choose
from 6Mbps, 9Mbps, 1Mbps, 18Mbps, 4Mbps, 36Mbps, 48Mbps, and
54Mbps.
Using the Configuration Menu
34