The Use Of A Fire Screen; Using A Blower - Drolet ESCAPE 1800 Installation And Operation Manual

4.1

The Use of a Fire Screen

This stove has been tested for use with an open door in conjunction with a fire screen, sold
separately. The fire screen must be properly secured on the stove to avoid any risk of sparks
damaging the flooring. When the fire screen is in use, do not leave the stove unattended to
respond promptly in the event of smoke spillage into the room. Potential causes of smoke
spillage are described in Section
Optional Fire Screen Installation»
Operating the stove with a fire screen increases possibilities of generating carbon monoxide. Carbon
monoxide is an odourless gas that is highly toxic which can cause death at high concentration in
air. Installation of a carbon monoxide detector is highly recommended.
4.2

Using a Blower

Figure 8: Air flow with a blower
The blower has a variable speed control that can be adjusted
in three different positions; either from high (HI) to low (LO) or
closed (OFF). Allow the stove to reach operating temperature
(approximately one hour) before turning on the blower, since
increased airflow from the blower will remove heat and affect
the start up combustion efficiency.
The blower can also be equipped with a heat sensor, sold
seperatly. When the blower is ON, it will start automatically
when the wood fire is hot enough and it will stop when the
wood fire has cooled down. Therefore, the blower speed control
can be left at the desired setting. See
Thermodisc Installation»
When the blower is on (position between HI and LO), the heat
sensor will make the blower start automatically when the stove
is hot enough and will stop it when the stove has cooled down.
Therefore, the blower speed control can be left at the desired
setting.
Page 16
«8. The Venting System»
for installation instructions.
A blower is included with this stove. The blower is already
installed at the back of the stove, the power cord can be
found in the user manual bag. The blower is used to increase
the airflow through the heat exchanger and improve hot air
circulation in the room.
When used regularly, the blower can provide a small increase
in efficiency, up to 2%. However, the use of a blower should
not be used as a way to gain more output from a stove that
is undersized for the space it is intended to heat.
Ensure the blower cord is not in contact
with any surface of the wood fire to prevent
electrical shock or fire damage. Do not run
cord beneath the wood fire.
«Appendix 2: Optional
of this manual. See «Appendix 3:
HI
OFF
LO
Figure 9: Blower rheostat
Installation and Operation Manual - Escape 1800