Desa CDCFPRA Operation And Installation Manual page 24

opERaTiNG FiREplaCE
Continued
ON/OFF SERIES (MODEL HRC100
SERIES)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 43).
press both buttons on hand-held
TO LOCK
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
press both buttons together
TO UNLOCK
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 43 - ON/OFF Hand-Held Remote
Control Unit
THERMOSTAT SERIES (MODEL
HRC200 SERIES)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 44). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Note: Do not leave the hand-held remote in the
AUTO mode close to the fireplace. The radiant
heat from the fireplace will turn off the fireplace.
Ideally, place the hand-held remote in the center
of the room facing towards the fireplace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Locks
System to
Prevent
Accidental
Ignition
Control
Turns
Button
Burners
On or
Off
Increases or
Decreases
Room
Temperature
in AUTO Mode
Figure 44 - Thermostat Hand-Held
Safety Features
When away from home for an extended period
of time or as a child safety feature to prevent
accidental ignition of the fireplace, the receiver
ON/OFF/REMOTE switch should be in the
OFF position.
Auto Shutoff Feature
1. If the average room temperature exceeds 82
degrees Fahrenheit (28 degrees Centigrade),
the hand-held remote control will perform a
safety override and shut the fireplace off. This
feature is not available in the MANU mode.
2. The receiver continuously receives signals
from the hand-held remote to control the
room temperature. If the hand-held remote
is misplaced, obstructed, or for any reason
cannot transmit to the receiver, the receiver
will shut off the fireplace after 8 minutes.
www.desatech.com
Digital Display Shows
Temperature and Settings
AUTO
ROOM SET
TEMP TEMP
TEMP
LOCK
POWER
MANU AUTO
ºC/ºF
°C/°F
Selects
Mode
AUTO
Button
Mode
Remote Control Unit
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
116658-01D