Desa CDCFPRA Operation And Installation Manual page 19

iNsTallaTioN
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Installing Receiver
1. Disconnect wires from the control valve (see
Figure 28).
2. Locate the battery clip mounted on the back
of the receiver (see Figure 29).
3. Slide 9-volt battery (not included) through the
clip.
4. Attach the terminal wires to the battery (see
Figure 29).
5. Connect wires from remote receiver to control
valve as shown in Figure 30.
6. Install remote receiver unit onto remote/
blower bracket using screws provided (see
Figure 30).
Figure 28 - Disconnecting Wires From
Control Valve
Receiver
-Volt
Battery
Figure 29 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Figure 30 - Installing Remote Receiver
116658-01D
Terminal
Wires
Battery Clip
Red Wire to
TPTH Terminal on
Control Valve
www.desatech.com
Installing 9-volt battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery (not includ-
ed). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Battery
Cover
Terminal
Wires
-Volt Battery
Figure 31 - Installing Battery in Hand-
Held Remote Control Unit
OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1
WARNING: Read and fol-
low installation instructions.
Installation should be done by
a qualified installer familiar with
low-voltage wiring procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Remove jumper wire from control valve (see
Figure 26).
2. Connect one terminal of 25 ft. wire to the
"TH" terminal on the control valve. Connect
the other terminal to the "THTP" terminal on
the control valve. See Figure 32, page 20.
3. Route the 25 ft. wire to a convenient location
to mount your thermostat (no outside wall).
IMPORTANT: The wire may be shortened
but must not be lengthened.
The thermostat should be mounted 54" above
the floor in a location where there is good
air circulation. Avoid heat sources such as
lamps, direct sunlight, fireplace, or heat and
air conditioning ducts.
Remote Control Unit
Battery
Housing
1