Desa CDCFPRA Operation And Installation Manual page 23

opERaTiNG FiREplaCE
Continued
8. Slightly push in and turn control knob coun-
terclockwise
9. Set flame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Pilot Burner
Figure 40 - Propane/LP Gas Pilot
Pilot Burner
Figure 41 - Natural Gas Pilot
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise
the OFF position.
2.
If Using Optional Hand-Held Remote:
lector switch in the OFF position to prevent
draining battery.
Shutting Off burners Only (pilot stays lit)
You may shut off the burners and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
the PILOT position.
2.
If Using Optional Hand-Held Remote:
remote control manual OFF button.
WARNING: Make sure remote
sensor selector switch is in the
OFF position when you are away
from home for long periods of
time.
116658-01D
to the ON position.
Ignitor
Electrode
Ignitor
Electrode
Set se-
Use
www.desatech.com
MANUAL LIGHTING
1. Follow steps 1 through 5 under Lighting
Instructions, page 22.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 8 and 9
under Lighting Instructions, column 1.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page 44).
Follow instructions included with the remote
control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 22.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 42).
Note: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
to
is not lit. This will drain the battery.
REMOTE
OFF
ON
to
Selector Switch in Remote Position
(Optional Remote Control)
Figure 42 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
PROCEDURE
Flame
Adjustment Knob
Control
Knob
IN
OUT
LO
3