Activating Do Not Disturb; Activating Malicious Call Trace - 3Com VCX Manual

40 C 4: B
HAPTER ASIC
Activating Do Not
Disturb
Activating
Malicious Call Trace
T O
ELEPHONE PERATION
When you enable Do Not Disturb, incoming calls immediately go to the
call coverage point set by you or your administrator. The default call
coverage point is your voice mailbox. The call coverage point is set
through the VCX User Interface (see
When your telephone is in Do Not Disturb mode:
An incoming call does not cause your telephone to ring. If you are
■
logged in to multiple telephones using the same telephone number
and one of the telephones enables Do Not Disturb, the feature applies
to all telephones—an incoming call will not ring on any of the
telephones.
You can use the telephone to dial outgoing calls.
■
If you enable Do Not Disturb while one or more calls are ringing, the
■
pending calls are sent to your call coverage point and Do Not Disturb
is enabled for all subsequent calls.
If you are a Hunt Group member and you enable Do Not Disturb,
■
personal (non-Hunt Group) calls go to your call coverage point.
However, Hunt Group calls always ring on a member's telephone,
regardless of the Do Not Disturb setting.
To activate Do Not Disturb:
1 Press Feature + 446.
Your telephone is now in Do Not Disturb mode. The display panel shows
DND.
2 To disable Do Not Disturb mode, repeat step 1. The DND message
disappears from the display panel.
The Malicious Call Trace feature enables you to notify the system if you
receive a harassing or abusive call. The calling party can be from either an
external or internal source.
Malicious Call Trace cannot be invoked when you are on a conference
call.
To activate malicious call tracing during a call, press Feature + 119.
The Display Panel shows
Chapter
for 5 seconds.
malicious call
7).