Connect The Power Cord, Turn On The Machine - Canon ImageClass MF4270 Starter Manual

Connect the Power Cord, Turn On the Machine

1
Connect the power cord into the rear socket on the back side of the machine and the wall outlet, and
press the [I] side of the main power switch (A) to ON.
2
The machine enters the standby mode.
The LCD display turned off:
●
The machine may enter the sleep mode while you are setting up the machine. Press
on and continue the setup.
<CLOSE COVER/TONER COVER> is displayed:
●
Make sure that the toner cover and scanning platform are closed properly. (See "Install Toner Cartridge, " on p. 6.)
<SET PAPER AGAIN/SET TONER AGAIN> is displayed:
●
Check the installation of the toner cartridge and the placement of the paper. (See "Install Toner Cartridge, " on p. 6 and "Set Up the
Paper Cassette and Load Paper, " on p. 9.)
This product emits low level magnetic flux. If you use a cardiac pacemaker and feel abnormalities, please move away from this
product and consult your doctor.
–
If you loaded paper other than A4, make sure to set the correct paper size in the machine. (See Chapter 2, "Document and Paper, "
in the Reference Guide.)
–
Any data stored in the memory, including received fax documents, will be deleted if you turn off the main power switch of the
machine.
–
During electrical storms, disconnect the power cord from the power outlet. (Please note that received documents stored in the
machine's memory may be lost when you unplug the machine.)
–
Whenever you unplug the machine, wait at least five seconds before you plug it in again.
–
Do not plug the machine into an uninterruptible power supply (UPS).
Ex.
1 0 0 % A 4
T E X T / P H O T O
Set Up the Machine
1
[Energy Saver] to turn the machine back
11