Helpful Hints - Kyocera FS-6025MFP User Manual

Helpful hints

All entries in the Command Center have to be confirmed using the "Send" button,
Entries
only then are the data sent to the device.
Some entries take a little time so be sure to keep an eye on the progress bar. Some entries take a little time so be sure to keep an eye on the progress bar
• The access password (admin00) should be changed as soon as possible so that
Password
• In principle, it is possible NOT to define ANY password. Access to the Command
The password can only be changed in the relevant Command Center menu. If the pass-
Password
word is not known, the Command Center can neither be accessed nor can a new
forgotten/
password be defined.
unknown
The following strategy is helpful if the access password is not known:
• While installing the device, a separate administrator account is set up (see page 96).
Important: The account must have administrator rights!
• This administrator account can be used to access system settings via operation panel.
• Local authentication can be activated via the system settings.
• After that the administrator account can be used to acccess the Command Center.
• Though the password has not been changed, all settings in the Command Center are
available.
• After making the required settings, local authentication (in the Command Center)
can be switched off again.
A password change, when the old password is not known, can only be carried out by
resetting the device:
• Reset via the Command Center
there is optimal protection
Center would then be unprotected (not recommended).
g
Though the password has not been changed all settings in the Command Center are
"Reset to factory settings" results in the loss of certain data. Make sure that
these data are saved before the reset is carried out.
LE 05 Command Center LE 05 Command Center
LE 05 Command Center LE 05 Command Center
, p p ( p g )