Kyocera FS-6025MFP User Manual page 34

LE 04 Maintenance LE 04 Maintenance
U-425, automatically calibration of the scanner ,
(Follow up)
1. Place the calibration chart on the contact glass.
2. Close the document processor carefully so that the chart
doesn't move.
3. Activate the maintenance mode.
4. U-411 and select „01 Table" .
5. Quit with OK.
The scanner starts its processes.
After 1 minute „OK" should displayed.
If the calibration is not successful the display shows „NG".
Control the position of the calibration chart and try it once
more.
Gray adjustment G dj t
The half-tone calibration is only in the
System Menu Adjustment/Maintenance
Gray adjustment
1. Print calibration chart 1
2. Put calibration chart on the contact glass and
start measuring.
3. Put calibration chart 2 (it came with the
machine) on the contact glass and push start.
After the calibration switch the machine OFF and
ON again.
y
t
Leading edge