Advertisement
•
Costs associated with assembly, required oil, adjustments or other installation and
start-up costs.
•
Expendable parts or accessories supplied with the product which are expected to
become inoperative or unusable after a reasonable period of use, including but not
limited to springs, nozzles, o-rings, washers, and similar accessories.
•
Merchandise sold by
as the product of another company, such as gasoline engines. The product
manufacturer's warranty, if any, will apply.
•
ANy INCIDENTAL, INDIRECT OR CONSEQUENTIAL LOSS, DAMAGE,
OR ExPENSE ThAT MAy RESULT fROM ANy DEfECT, fAILURE OR
MALfUNCTION Of ThE PRODUCT IS NOT COVERED By ThIS WARRANTy.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
IMPLIED WARRANTIES, INCLUDING ThOSE Of MERChANTABILITy OR
•
fITNESS fOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE yEAR fROM
ThE DATE Of ORIGINAL PURChASE. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitations may not apply to you.
OPERATIONAL
ISSUE
Engine will
not start
(see Engine
Owner's
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
SIMPSON
®
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSE
No fuel
Pressure builds up after
two pulls on the recoil
starter or after initial use
Choke lever in the "No
Choke" position
Spark plug wire not attached
Engine switch in OFF
po si tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time.
Spray wand not in
high pressure
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
Water filter screen clogged
which has been manufactured by and identified
SOLUTION
Add fresh fuel
Squeeze gun trigger to relieve
pres sure
Move choke to the "Choke"
po si tion
Attach spark plug wire
Place engine switch
in ON position.
Move choke to the "No
Choke"
po si tion.
See how to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 PSI
Repair leak. Apply sealant
tape if necessary
See Nozzle Cleaning
instructions in the
Maintenance section
Remove and clean filter.
See Cleaning Water Inlet
filter paragraph in the
Maintenance section for
the correct procedure
20- ENG
Advertisement
