Advertisement
&
WARNING: Risk
of unsafe operation.
If engine does not
start
after two
pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord
slowly
until resistance is felt. Then pull cord rapidly
to
avoid kickback and prevent
hand or ann injury.
NOTE: If
the oil level in the engine is low, the engine will not start.
If
the engine
does
not start, check the oil level and add oil as needed.
11
. Depress
trigger on gun to start water flow
.
.&.
WARNING: Risk of unsafe operation. Stand on
a
stable surface and
grip gun/spray wand firmly with both hands. Expect the gun
to
kick when
triggered.
12.
Release
trigger to stop water flow
.
.&.
WARNING: Risk of injury from spray. Always engage
the trigger lock (OJ when gun is not in use. Failure to do
so
could
cause accidental spraying.
SHUTTING DOWN
1.
After each use, if you have applied chemicals, place
detergent siphon hose into container of clean water and
draw clean water through chemical injection system to
'---------==----'
rinse
system thoroughly.
NOTICE:
Risk of property damage. Failure to do
so
could
cause
damage to the
pump.
2.
Turn
engine off. See
Engine Owner's Manual.
NOTICE: Risk
of property damage.
NEVER
tum the water off with the engine
running.
3.
Turn
water source off.
4.
Pull
trigger on spray gun to relieve any water
pressure
in hose or spray gun.
NOTE: Failure
to release system pressure will
prevent removal
of high pressure
hose from spray gun or pump connection.
5.
See
Storage
section in this manual for proper storage
procedures.
MAINTENANCE
&
WARNING: Risk of burn hazard. When performing maintenance, you may
be exposed
to
hot
surfaces,
water pressure or moving parts that can cause
serious injury or death
.
.&.
WARNING: Risk of fire hazard. Always disconnect,
spark
plug wire,
let the engine cool and release all water pressure before perfonning any
maintenance or repair. The engine
contains
flammable fuel. Do not
smoke
or
work near open flames while performing maintenance.
To
ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should
be
prepared and followed.
If
the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
ENGINE
Consult the
Engine Owner's Manual
for the manufacturer's recommendations
for any and all maintenance.
NOTE: The
engine drain plug is located at the rear of
the unit.
16- ENG
Advertisement
