Advertisement
NOTICE:
Risk of property damage.
Never
pull water supply hose to move pressure
washer. This could damage hose and/or pump inlet.
•
00 NOT use hot water, use cold water only.
•
Never tum water supply off while pressure washer engine is running or damage to
pump will result.
•
DO NOT stop spraying water for more than two minutes at a time. Pump operates
in bypass mode when spray gun trigger is not pressed. If pump is left in bypass
mode for more than two minutes internal components of the pump can be
damaged.
If you do not understand these precautions, please contact our customer service
department at www.simpsoncleaning.com
Prior to starting, refer to your engine manual for proper starting procedure.
1.
In
a well ventilated outdoor area add fresh, high quality, unleaded gasoline
with a pump octane rating of
86
or higher.
Do
not overfill.
Wipe
up spilled
fuel before starting the engine.
Refer
to
Engine Owner's Manual
for correct
procedure.
--Ethanol
Percentage
- -
NOTICE:
Use of fuels with greater than 10% ethanol are
Slo%~
T
~
15 %_ 30 %- 85 %
l
not approved for use
in.
this product per EPA regulations
X:
W
l
W
')and
will damage the unit and void the warranty.
2.
Check engine oil level.
Refer
to
Engine Owner's Manual
for correct procedure.
3.
Connect the water hose to the water source.
Turn
the water source on to
remove
all air from the hose.
When
a steady stream of water is
present,
turn
the water source off.
4.
Verify the filter screen (Q) is in water inlet of pump.
NOTE: Convex
side faces
out.
5.
Connect water source (N) to pump inlet (J).
NOTE: Water
source must provide
a minimum of 5 gallons per minute at 20
PSI.
6.
Connect high pressure hose (C) to pump outlet (1)
.
•
&
WARNING: To reduce the possibility of contamination always protect
against backflow when connected to a potable water system.
7.
Choose the correct nozzle for the job to be performed. See
How To Use spray
Wand
instructions in this section.
NOTE: If
applying a chemical or cleaning
solution, see
How To Apply Chemicals/Cleaning Solvents
instructions in this
section.
8.
Turn
water source on.
NOTICE: Risk
of property damage. Failure to do so could cause damage to the
pump.
9.
Remove
all air from the pump and high pressure hose by depressing trigger
until a steady stream of water is
present.
10.
Start engine. See
Engine Owner's Manual
for correct
procedure.
15- ENG
Advertisement
