Atx Power Connectors; Chassis Intrusion Connector - Asus M2N-SLI Hardware User Manual

8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
M2N-SLI DELUXE
R
M2N-SLI DELUXE Chassis Intrusion Connector
9. ATX power connectors (24-pin ATXPWR, 4-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
M2N-SLI DELUXE
R
M2N-SLI DELUXE ATX Power Connector
ASUS M2N-SLI Deluxe
CHASSIS
ATX12V
GND
GND
+12V DC
+12V DC
(Default)
EATXPWR
+3 Volts
+3 Volts
-12 Volts
+3 Volts
Ground
Ground
PSON#
+5 Volts
Ground
Ground
Ground
+5 Volts
Ground
Ground
-5 Volts
Power OK
+5 Volts
+5V Standby
+5 Volts
+12 Volts
+5 Volts
+12 Volts
Ground +3 Volts
2-2