Atx Power Connectors (20-Pin Eatxpwr1, 4-Pin Eatx12V1); Hard Disk Activity Led Connector (4-Pin Hdled1) - Asus P11C-I Manual

11. ATX power connectors (24-pin EATXPWR1, 4-pin EATX12V1)
These connectors are for the ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
• DO NOT forget to connect the 24-pin and the 4-pin power plugs; otherwise, the system
will not boot up.
• Use of a power supply unit (PSU) with a higher power output is recommended when
configuring a system with more power-consuming devices. The system may become
unstable or may not boot up if the power is inadequate.
• This motherboard supports ATX2.0 PSU or later version.
• Ensure that your PSU can provide at least the minimum power required by your
system.
12.

Hard disk activity LED connector (4-pin HDLED1)

This LED connector is for the storage add-on card cable connected to the SATA or
SAS add-on card. The read or write activities of any device connected to the SATA or
SAS add-on card causes the front panel LED to light up.
ASUS P11C-I
2-31