Configure The Dhcp Server; Global Dhcp Configuration - D-Link DWL-3500AP Configuration Manual

1.2. Configure the DHCP Server

The wireless switch can function as a DHCP server to assign addresses to wireless (or
wired) clients that connect to each AP. To configure the DHCP Server, you must
configure global settings and the address pool for the clients.
For this scenario, wireless clients will be assigned addresses in the range of 10.90.91.1/8 –
10.90.91.254/8. By limiting the range of addresses, you can then configure an ACL to limit the
network access of all clients that have addresses within this range and still maintain additional
addresses in this space for static configuration for clients or servers.
Since these addresses are on the 10.0.0.0 network, you must exclude all addresses that are not in
the range.
GuestPool
10.90.91.1 – 10.90.91.254

1.2.1. Global DHCP Configuration

Use the following procedures to configure the global DHCP settings.
Select the LAN tab from the navigation panel and access Administration
1.
Server
Global Configuration.
2. Enable the Admin Mode
3. Add the excluded addresses as following:
a. 10.0.0.0 through 10.90.91.0
b. 10.90.92.0 through 10.255.255.255
Excluded Addresses
10.0.0.1 - 10.90.91.0
10.90.92.0 – 10.255.255.255
Subnet Mask
255.0.0.0
DHCP