Wireless Configuration - D-Link DWL-3500AP Configuration Manual

1.4. Wireless Configuration

You configure and monitor all wireless settings from the WLAN tab on the navigation panel.
Since the deployment is an L2 Edge and there are no subnet boundaries to cross, the switch can
use the network management IP address for the wireless functions (Note: the wireless switch
component uses an IP address to manage the APs and peer-switches. In a L2 environment like
this scenario no inter-subnet routing is required. If however the scenario involves a L3
environment where wireless components including APs and peer-switches cross subnet
boundaries, a routing interface must be used, such as a loopback interface).
It is important to set the correct country code on the switch so that the APs operate in the
correct regulatory domain.
1. To configure wireless features, select the WLAN tab from the left pane and traverse
down the navigation tree to Administration
2. Select the Global tab in the right pane and make sure Wireless Switch Mode is
enabled
3. Select the appropriate country code then click the Submit to submit the request.
Note: This scenario uses the default AP profile configuration, so you do not need to configure
any AAA/RADIUS, Radio, or SSID settings.
Note: The IP address on the Wireless Global Configuration page is the default management IP
address of the switch (10.90.90.90).
Basic Setup.