Broil Element; Ribbon Elements; Oven Door Removal; Oven Door Hinge Receiver - Magic Chef CER3725AGW Service

Disassembly Procedures
!

Broil Element

1. Turn power off.
2. Remove screws securing broil element to top and
rear of oven cavity.
3. Pull broil element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedure to reinstall broil element.

Ribbon Elements

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.
4. Release metal clips securing element to element
support bracket.
5. Replace and reverse procedure to reinstall element.

Oven Door Removal

!
WARNING
To avoid risk of personal injury or property damage,
do not lift oven door by the handle.
1. Open oven door slightly and grasp door on both
sides.
2. Lift up and off the hinge receivers.
3. Reverse procedure to reinstall oven door.

Oven Door Hinge Receiver

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure.
4. Remove side panel, see "Side Panel Removal"
procedures.
5. Remove storage drawer, see "Storage Drawer
Removal" procedure.
6. Remove the top and bottom screws securing hinge
receiver to the front frame.
7. Remove hinge receiver from oven chassis.
8. Reverse procedure to reinstall oven door hinge
receiver.

Side Panel Removal

1. Turn power off.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure.
© 2006 Maytag Services
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing,
unless testing requires power.
4. Remove screws securing lower rear galvanized cover
from unit.
5. Remove screws securing top and back of side panel.
6. Pull rear of side panel away from range then slide
side panel forward to release from side panel
spacers.
7. Reverse procedure to reinstall side panel.

Backguard

NOTE: Requires removal of oven from installation
position.
1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing upper back panel form unit.
3. Remove screws securing bottom outside edges of the
backguard to unit chassis.
4. Reverse procedure to reinstall backguard.

Storage Drawer Removal

1. Pull drawer straight out to first stop. Lift the front and
pull out to second stop.
2. Let front of door rest on floor. Place hands toward
back of drawer and lift it out.
3. To replace:
a. Place the set of rollers on the drawer behind the
set of rollers on the oven. (As shown above.)
b. Align the guides and push the drawer back into
position.

Storage Drawer Track Removal

1. Remove the storage drawer by pulling it out to the
fully open or stop position, lifting the drawer at the
rear to disengage the drawer track rollers from the
drawer runners, and sliding the drawer out of the
range.
2. The tracks are mounted to a rear support and the
frame of the range. Remove the two track mounting
screws and remove the track. If the track support is
being replaced, remove the mounting screw securing
it to the side frame and remove the support.
16026839 17