Installing The Sata Dom; Cable Routing For Sata Dom And Lsi 2008; Power Supply Units - Dell PowerEdge C6320 Owner's Manual

Installing the SATA DOM

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Holding the SATA DOM by its edges, position it so that the card edge connector aligns with the
onboard SATA connector 5 on the system board.
2. Press the SATA DOM with your thumbs until it is fully seated.
3. Reconnect all the cables.

Cable routing for SATA DOM and LSI 2008

Figure 34. Cable Routing for SATA DOM and LSI 2008
Item Cable
Mini-SAS cable
SATA DOM
power cable

Power supply units

NOTE: The following table lists the maximum supported configuration where power supply unit
redundancy is guaranteed.
NOTE: Configurations higher than indicated in the table may change the power supply unit mode to
non-redundant. In non-redundant mode if the power requirement exceeds the installed system
power capacity, the BIOS will throttle the processors. Also, if Processor Power Capping is enabled,
then processor throttling occurs on configurations that exceed the cap value.
NOTE: Both the power supply units are swappable, and they can support hot swap in any condition
if the system has power throttling feature.
From (LSI 2008 SAS Mezzanine
Card)
Mini-SAS connector 4~7 (J4)
On LSI 2008 SAS Mezzanine Card
Mini-SAS connector 0~3 (J3)
On LSI 2008 SAS Mezzanine Card
SATA DOM
To (System Board)
SAS/SATA connectors 4&5
Mini-SAS HD Connector 0-3
HDD Power Connector on the
system board
61