Dell PowerEdge C6320 Owner's Manual page 100

Figure 70. Removing and installing the middle-wall bracket
1. middle-wall bracket
7. Disconnect all the cables from the upper middle plane.
Note the routing of the cable on the chassis as you remove them from the system. You must route
these cables properly when you replace them to prevent the cables from being pinched or crimped.
8. Remove the screw that secures the power cable cover to the upper middle plane.
9. Lift it up straight from the locking hole on the upper middle plane. Then, lift it completely out of the
upper middle plane.
Figure 71. Removing and installing the power cable cover
1. screw
10. Remove the four screws that secure the power cables to the upper middle plane.
100
2. screw (6)
2. power cable cover