Moving Machine By Hand - Dixon SPEEDZTR 46 Operator's Manual

Moving Machine By Hand

When pushing or pulling the mower, engage the
eZT bypass linkages. The eZT bypass linkages are
located on the rear of the frame, below the rear engine
guard.
1. Raise the deck into the highest cutting position.
2. Pull the eZT bypass linkages up and out of the
keyhole slots. Release the levers with the head
outside the frame and held in the bypass position.
3. To reengage the eZT's to drive, reverse the above
procedure.
4. load the machine into truck or trailer by driving
up ramps in low gear. DO NOT lIfT! The machine
is not intended to be lifted by hand.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
WARNING!
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of serious
injury or death if the machine falls off the
ramps.
34
opeRatIon
Bypass linkages
1. eZT engaged
2. eZT locked in the bypass
Bypass linkage - left hand side
2
1
8058-150
8058-147