Fuel Shut Off Valve; Cutting Height Adjuster; Tracking - Dixon SPEEDZTR 46 Operator's Manual

Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of the
seat. The valve is off when the handle tab is turned
perpendicular to the fuel line.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.

Cutting Height Adjuster

To set the desired deck cutting height, press the
release button and move the lever forward to the
correct cutting height on the cutting plate. The cutting
height range is from 1½" (38mm) to 4" (102mm) in ½"
(13mm) increments. The heights are measured from
the ground up to the blade tip with the engine not
running.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the tracking
bolts. The tracking bolts act as limiting devices for
the motion control levers when in the full-forward
position.
2. for preliminary tracking adjustment, move unit
to an open, unobstructed area such as an empty
parking lot or open field.
3. back the tracking bolts out until flush with nut.
4. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
5. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight.
22
ContRols
Fuel shut off valve in the CLOSED position
Mower deck lifting lever
Tracking bolts
8011-419
8058-256
8058-256