Operation
the hand held transmitter.
2.
Install one 12-Volt (A23)
battery in the battery holder.
3.
Close the battery cover.
Remote Control
Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to re-
initialize the hand-held transmitter
and the remote control receiver in
the fireplace:
1.
Place the
Switch (Figure 4A) in the
oFF ("o") position.
2.
Wait a minimum of five (5)
seconds and then place the
Main ON/OFF Switch in the
12
Main ON/OFF
Figure 5
On
Button
Off
Button
remote Control ("=") position.
3.
Within
10 seconds of
changing the switch position,
press the on button located
on the remote control
transmitter (Figure 4).
This will synchronize the remote
control transmitter and the
fireplace receiver.
! NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will result
in these steps needing to be
followed again.
If you are still experiencing issues
with your remote control, contact
Dimplex North America Limited
Customer Service at 1-888-346-
7539, or visit the Dimplex website
at www.dimplex.com.
Battery
Battery
Cover
www.dimplex.com