Pace TDC778X Operator's Manual page 34

MAKING USER SETTINGS (cont.)
If you have not done so, put your set-top into "user settings mode", as described on page 21. The
front panel displays "ASPt".
The flow diagram on the right shows how you use the arrow, select and power buttons on your
set-top's front panel to change the display and make the settings. See also the instructions below.
1. Press the D button until the front panel displays "rSEt" (short for "restore factory settings"), as
shown right.
2. Press the R button. "yes" appears on your set-top's front panel. (If you no longer wish to restore
the factory settings, press the L button.)
3. To restore the factory settings, press the select button.
4. The factory settings are restored. If you want to continue changing the settings, press L then see
the sections from page 21 onwards. If you have finished changing the settings, press the power
button. Your set-top will switch on with the restored settings.
If your set-top and HDTV are connected via a HDMI cable, your HDTV may pass information about the
required settings back to your set-top (see page 23). If you wish to restore your set-top's settings to those
created by your HDTV, you should disconnect your set-top from your HDTV before you restore the
factory default settings. When you reconnect your HDTV to your set-top via the HDMI cable, your HDTV
will pass back the information again.
Always turn off your set-top, wait 60 seconds, then disconnect your set-top from the wall AC
outlet before you connect or disconnect any other equipment to or from its rear panel.

NOTES