Pace TDC778X Operator's Manual page 26

MAKING USER SETTINGS (cont.)
Changing the TV Display Capability
If you have not done so already, put your set-top into "user settings mode", as described on page 21.
The front panel displays "ASPt".
The flow diagram on page 25 shows how you use the arrow and select buttons on your set-top's
front panel to change the display and make the settings. See also the instructions below.
1. To change the TV Display Capability press the D button. The front
panel displays "res" (short for "resolution"), as shown in the flow diagram.
2. Press the R button. The first TV Display Capability resolution appears on
the front panel (1080i, although it is displayed as 1080). Depending on
the set-up, you may also see the TV Display Capability menu, shown right,
on your TV screen.
3. To check the resolution's setting, press the R button. * Either "yes"
(selected) or "no" (not selected) is displayed. If you can see the on-
screen menus, the menu shown right appears.
- If this is the correct setting, press the L button. The front panel will
display "1080" again.
- If you want to change the setting, press U or D. (On the on-screen menu, the highlight moves
between the available settings). Press the select button to confirm your choice and change to
the new setting. Then press the L button. The front panel displays "1080" again.
4. Press U or D to display each resolution in turn, and repeat step 3 for each. The available resolutions
are: 1080i, 720p, 480p and 480i. (See pages 23 and 25 for more information about these).
5. When you are satisfied that all the TV resolutions are correct, press the L button. The front panel

displays "res" again. To continue making the settings, see page 26.
TV Display Capability
1080i : YES
720p : NO
480p : YES
480i : YES
1080i
Yes
No
*If you use the select button at
step 3, it will change the setting. If
you accidentally press the select
button, and the menus disappear
from your screen, immediately
press the select button again to
restore the menus.
NOTE