Note to the installer To ensure correct operation, use this set-top box only with the Pace- approved power supply unit provided. If you use an unapproved alternative, This reminder is provided to call the attention of the cable-TV-system you will invalidate the warranty.
The wide blade or the third prong are provided for your safety. If the Service address: provided plug does not fit into the outlet, consult an electrician for Pace Americas Inc. replacement of the obsolete outlet. 3701 FAU Boulevard, Suite 200, Boca Raton, Florida 33431 U.S.A.
SAFETY INFORMATION (cont.) Lightning In addition to the Important Safety Instructions, please read the Safety Information below. For added protection for your set-top box during a lightning storm, or when it is left unattended and unused for long periods of time, disconnect Power sources the cable system from your set-top box.
Page 7
SAFETY INFORMATION (cont.) Ventilation Water and moisture Slots and openings in the casing of your set-top box are provided for Do not expose your set-top box to rain or moisture, dripping or splashing, ventilation, to ensure reliable operation of your set-top box and to protect it and ensure that no objects filled with liquids, such as vases, are placed on from overheating.
Page 8
Therefore you must install your set-top box near to the wall AC outlet, which Pace-approved power should be easily accessible. supply unit provided. If you use an unapproved If you are in any doubt about the power supply cord, its plug or its...
SAFETY INFORMATION (cont.) Regulatory information NOTE CAUTION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • Do not attempt to modify your set-top box without written (1) this device may not cause harmful interference, and authorization from the manufacturer. Unauthorized (2) this device must accept any interference received, including modification could void your authority to operate your set-top interference that may cause undesired operation.
REAR PANEL SD Card (future use) For use only during servicing Power input To TV CableCARD™ module Audio Out Component Video Cable In (Make this RF output to TV (behind cover) Removal Audio outputs Component video output For connection From cable connection (or VCR) will interrupt your service...
Page 11
REAR PANEL (cont.) Cable In Connect the cable service here. To TV Connect to the RF/antenna input on your TV or VCR (optional). CableCARD module Removal will interrupt your service. Audio Out Connect to the L and R audio inputs on your stereo TV, stereo VCR, or optional stereo amplifier. Component Video If your HDTV does not have an connector, connect your HDTV here.
CONNECTING THE EQUIPMENT In order for you to view programs broadcast in high-definition, your set-top box must be connected to a suitable WARNINGS HDTV or computer monitor. Do not connect your set-top box Your equipment should have been connected up by your installer. However, if you need to disconnect and (or any other equipment such as a TV or VCR) to the power supply reconnect your equipment, read pages 10 through 14.
CONNECTING THE EQUIPMENT (cont.) Setup A - Home theater system with HDTV NOTE (HDMI connection) Copy protection via an HDMI secure link Setup A (see page 12) uses an connector to connect to the HDTV. This displays the highest quality picture HDMI on the HDTV and also means there will be no picture degradation on any copy-protected programs (provided the The HDMI link between your set- link remains secure –...
Page 14
CONNECTING THE EQUIPMENT (cont.) Setup A: (HDMI HDTV RIGHT AUDIO IN LEFT AUDIO IN ANTENNA/ VIDEO IN RF IN COMPONENT VIDEO IN HDMI COMPOSITE COMPONENT Y IN VIDEO OUT VIDEO OUT POWER LEFT PB IN AUDIO DIGITAL AUDIO OUT RIGHT POWER PB/CB PR IN...
Page 15
CONNECTING THE EQUIPMENT (cont.) Setup B: (Component video) RIGHT HDTV AUDIO IN LEFT AUDIO IN VIDEO IN ANTENNA/ RF IN COMPONENT VIDEO IN HDMI COMPOSITE COMPONENT Y IN VIDEO OUT VIDEO OUT POWER LEFT PB IN AUDIO DIGITAL AUDIO OUT RIGHT POWER PB/CB...
CONNECTING THE EQUIPMENT (cont.) WARNINGS Do not connect your set-top box (or any other equipment such as a TV or VCR) to the power supply until you have properly connected all the other cables. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
CONNECTING THE EQUIPMENT (cont.) Lightning storms Disconnect your set-top box’s power cord during lightning storms. A lightning storm may affect your set-top box, if it is on during the storm. It may appear that it has stopped working, but you can easily restore its operation as follows: To turn your set-top box on, Unplug your set-top box’s power supply unit from the wall AC outlet.
CONNECTING THE EQUIPMENT (cont.) Pairing your RF remote control with your set-top box NOTES If you are using an RF remote control, you must pair it with your set-top box, before you can use your set-top box Your cable TV service-provider with your TV.
FRONT PANEL Display Remote light Record light Power light Power button Lights green when your set-top Shows the time or the current Lights when you press a button Lights when a recording is To turn your set-top box is on and is not lighted channel number, and the setting on your remote control being made to the internal or...
3. You may not transfer any of your limited rights in the Software without the prior the Software); or written consent of Pace, and if consent is provided then the Software shall only be transferred in conjunction with the transfer of the Product AND ONLY IF the 5.