Mitel 6800i Series Administrator's Manual page 438

Mitel 6800i Series SIP Phone Release 4.0.0 SP1 Administrator Guide
softkey2 value: broadworks;*88
sip park pickup config: 70;70;asterisk
sip line1 park pickup config: *78;*98;broadworks
If the active call is using Line1, the phone will use the BroadWorks method for park (*78) and
pickup (*98) since per-line has the highest precedence.
If the active call is using any other line except Line1, the phone will use the Asterisk method
for park (70) and pickup (70) since it has precedence over the softkey value.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Expansion Module Key Settings for M680i and M685i"
and
"Programmable Key Settings"
Configuring a Park/Pickup Key Using Mitel Web UI
For all phones you first configure the park and pickup keys at Advanced Settings -> Line 1-N
by entering the appropriate value based on the server in your network.
Note: Applicable values depend on the server in your network (Asterisk, BroadWorks,
Sylantro, ININ). See the table below for applicable values.
For the 6867i and 6869i IP phones, you can enter a key label and change the sofkey states at
Operation->Softkeys and XML. The default state of the park configuration is "connected".
The default state of the Pickup configuration is "idle, outgoing". On the 6863i and 6865i IP
phones, you can enter a key label at Operation->Softkeys and XML.
Park/Pickup Call Server Configuration Values
SERVER
Asterisk
Sylantro
BroadWorks
ININ PBX
5-196
on
page A-235
on .
page A-223
PARK VALUES*
70
*98
*68
callpark
, on
"Softkey Settings" page A-214
PICKUP VALUES*
70
*99
*88
pickup