Location And Function Of Parts; Lens Attachment Section (Front) And Connectors - Sony CA-905K Operation Manual

Location and Function of Parts

Lens Attachment Section (Front) and Connectors

BKP-9057 Viewfinder
Saddle (not supplied)
qa Lens cable
q; REMOTE cable
9 CA cable
8 Accessory bracket
7 Number plate holder
1 Lens lock
Secures the lens by the tongue-like protrusion at the
lens bottom.
2 Lens lock holding knob
Secures the lens lock. Turn clockwise to tighten, and
counterclockwise to loosen.
3 Lens connector (36-pin)
Connect to the connector on the lens.
4 Cable clamp
Secures the camera cable. The diameter of the cable
with a diameter of 8 to 15 mm should be used with the
cable clamp.
Refer to System Manual for details on using the cable
clamp.
5 Lens mode switch
Selects one of the two lens communication modes.
During normal operation, set to NORMAL.
During use of a serial communication lens, set to
SERIAL.
5 Lens mode switch
6 CCU connector
6 CCU (camera control unit) connector (triax
connector: Kings type for the CA-905K, Fischer
type for the CA-905F; fiber connector: LEMO
type for the CA-905L)
Connects through a triax cable or fiber cable (not
supplied) to the CAMERA connector on the CCU-
550A/550AP/700A/700AP.
7 Number plate holder
Fit the supplied number plates.
8 Accessory bracket
Attach an optional accessory, such as a BKP-7911/
7912 Script Holder.
For attaching the accessory, refer to the instruction manual
supplied with the accessory.
9 CA (camera adaptor) cable (triax connector:
Kings type for the CA-905K, Fischer type for the
CA-905F; fiber connector: LEMO type for the CA-
905L)
Connect to the CCU connector on the camera adaptor.
q; REMOTE cable (8-pin)
Connect to the REMOTE connector on the camera
adaptor.
qa Lens connector (12-pin)
Connect to the LENS connector of the camera.
Lens mouth
1 Lens lock
2 Lens lock
holding knob
3 Lens connector
4 Cable Clamp
7 (E)