Sony CA-905K Operation Manual page 40

wa MIX VF (mix viewfinder) switch
Selects the picture in the viewfinder when the RET 1
or RET button is depressed.
ON: When the RET 1 or RET button is depressed,
the mixed picture of the camera output signal and
the return video signal (return video 1 or the
return video 2) can be monitored on the
viewfinder screen. The mixing ratio can be
adjusted with the control on the internal board of
the CCU-900/900P/700A/700AP.
For details, refer to System Manual.
OFF: When the RET 1 button or RET button is
pushed, only the return video 1 signal or return
video 2 signal can be seen.
Notes
• MIX VF switch does not work when the CCU-550A/
550AP is connected.
• When the CA-905L is used with the HDC-950, the
function of the MIX VF switch changes.
For details, see wj VF SCAN switch below.
ws SAFETY ZONE switch
ON: A box (safety zone) indicating 90% of the
picture appears on the viewfinder screen.
OFF: A safety zone does not appear on the
viewfinder screen.
You can change the size of the safety zone to 80%
with a menu on the camera.
For details, refer to System Manual.
wd CENTER MARKER switch
ON: A white cross (center marker) indicating the
center of the viewfinder screen appears on the
viewfinder screen.
OFF: A center marker does not appear on the
viewfinder screen.
You can adjust the position of the center marker to the
center of the lens to be used. The adjusted position
can be stored in a lens file.
For details, refer to System Manual.
wf CC (color temperature conversion) filter control
Selects a filter suitable for the lighting conditions
when the FILTER LOCAL button is lit.
Use a CCD unit with a built-in electric servo filter
unit or an optional electric servo filter.
For details on selectable filters, refer to the instruction
manual supplied with the camera.
Note
CC filter control does not work when the OHB-451 is
used.
12 (E)
wg ND filter control
Selects the ND filter when the FILTER LOCAL button
is lit.
Use a CCD unit with a built-in electric servo filter
unit or an optional electric servo filter.
For details on selectable ND filters, refer to the instruction
manual supplied with the camera.
wh FILTER LOCAL (filter local control) button
Press and light up this button to enable switching the
CC and ND filters using the CC and ND filter controls.
Press this button again so it goes out to return filter
control to the master setup unit or remote control
panel.
The qd PinP switch, ql spare switch, and wa MIX VF
switches provide different functions when the CA-
905L is used with the HDC-950. The new names of
these switches and their functions are described below.
Be sure to attach the rear-panel sticker (supplied with
the CA-950L) to the rear panel of the CA-905L at this
time. The functions of all other switches and controls
remain the same as described on pages 10, 11, and this
page.
wj VF SCAN (viewfinder scan) switch
Selects the aspect ratio of the viewfinder screen.
16:9: 16:9 aspect ratio
4:3: 4:3 aspect ratio
wk SCREEN SIZE MARKER switch
Selects the screen size marker on the viewfinder
screen.
ON ( ): Display area is bounded by two dark
margins.
ON( ): Display area is bounded by two white
lines.
OFF: No marker is displayed.
wl Assignable switch
A function specified by menu setting on the HDC-950
can be assigned to this switch.