Attaching A Portable Lens - Sony CA-905K Operation Manual

8
When the BKP-9057 viewfinder saddle is attached,
pull up the saddle and turn the saddle-locking knob
clockwise to secure the saddle.
9
Connect the remote cable to the remote connector
on the rear of this unit.
Connect the CA cable of this unit to the CCU
connector of the camera adaptor.
CCU
connector
CA cable
Removing the camera
Note
If the BKP-9057 is installed, remove the viewfinder first.
For details on removing the viewfinder, see page 20.
If the BKP-9057 viewfinder saddle is installed, pull
down the saddle and turn the saddle-locking knob
counterclockwise to loosen the saddle.
1
Remove the CA connector and remote cable from
the camera adaptor.
2
Turn the lens-locking lever upward.
3
Slide the slide lever to LOCK.
Note
The lens cannot be removed unless the slide lever
is set to LOCK.
4
Remove the VF connector and the LENS
connector.
5
Safety lever
Saddle-locking knob
Note
If, after removing the camera, the camera mounting
pin protrudes from the center of the lens attachment
section, it will not be possible to connect the camera to
the unit. If so, push the release lever while pushing the
safety lever.

Attaching a portable lens

Only lenses with a built-in extender can be used.
remote
connector
remote cable
1
2
3
4
Push the safety lever and release lever to remove
the camera.
Lens mouth
Portable lens
Lens mount
Insert the camera into the unit, following the
procedure in Section "Attaching the Camera"
(page 14). Slide the slide lever forward and hook
the slide lever.
Insert the mount joint of the portable lens mouth
on the front of this unit and connect to the
camera's lens mount.
Supporting the lens, turn the lens locking lever
downward.
Insert the lens cable of the portable lens through
the lens mouth of this unit, and connect to the
LENS connector of the camera.
Release
lever
Mount joint
Hook
Lens locking lever
17 (E)