Attaching The Camera - Sony CA-905K Operation Manual

Fitting the Camera, Equipment and Accessories
Notes
• Do not use lens ID:F. If the lens ID number is set to
F, change it to another ID number. For details on
verifying or changing the ID number of the lens, refer
to the instruction manual of the lens.
• If you use a serial communication lens, more lens
data can be captured by the camera by switching the
lens mode switch to SERIAL. Normal lens operation
is also possible with the switch set to NORMAL.
5
Remove the lens cap.

Attaching the Camera

The explanations in this manual use the BVP-950/
950P as an example. The positions of the VF
connector and lens connector on the certain cameras
differ from those on the BVP-950/950P.
Preparing the camera
1
If the BKP-9057 viewfinder saddle is attached to
the CA-905K/905F, turn the saddle lock knob
counterclockwise to loosen it, then tilt the saddle
backward.
Saddle lock knob
2
Remove the 1.5-type viewfinder.
Push the viewfinder slide inward.
14 (E)
3
Aligning the camera mount
After you have aligned the camera mount once, you
need not align it again if the same camera model is
used.
Release lever
Slide lever
1
VF connector
Turn the lens locking lever upward and remove the
lens mount cap.
Slide the slide lever to LOCK.
Lens locking lever
Lens mount cap
Height-adjusting
knobs