Table of Contents
Advertisement
Fitting the Camera, Equipment and Accessories
Removing the viewfinder
Before detaching the viewfinder, make sure the two
following conditions exist:
• The lift-release knob on the viewfinder is at its lowest
position.
• The lock lever on the viewfinder is set all the way to
the right.
The lift-release knob is at this position.
The lock lever is fully to the right.
1
Turn the pan lock lever clockwise, then turn the
viewfinder mount clockwise 90 degrees (to the
only point where the mount can be released).
2
Pull the handle of the viewfinder while pushing the
viewfinder release button, and lift up the
viewfinder.
Panning lock lever
20 (E)
Attaching the number plates
Insert the projections on the both sides of the number
plates into the notches in the holder.
Attaching the rear-panel sticker
When the HDC-950 is used, attach the rear-panel
sticker (supplied with the CA-950L) to the rear control
panel of this unit as shown below.
Viewfinder release
button
Number plate
2
Number plate holder
VF
UP
SCREEN
SCAN
TALLY
SIZE
DISPLAY
16:9
ON
MARKER
ON
ON
OFF
4:3
OFF
OFF
MENU
Rear-panel sticker
Advertisement
Chapters
Table of Contents
