Its-Dx4020-G Communicator Configuration; Its-Dx4020-G Communicator Overview - Bosch ICP-EZM2 Easy Series System Reference Manual

62 en | ITS-DX4020-G Communicator Configuration
9

ITS-DX4020-G Communicator Configuration

9.1

ITS-DX4020-G Communicator Overview

The ITS-DX4020-G provides wireless communications between the control panel and the
central monitoring station (CMS). You can configure the ITS-DX4020-G using one of two
methods:
–
–
Figure 9.1 ITS-DX4020-G Communicator
1 Mini USB Port
2 Antenna Connector
3 CONFIG MODE (J200) Jumper Pins
4 LED DIS (J201) Jumper Pins
5 STATUS LED
6 CELL IP LED
7 AUDIO ACT LED
NOTICE!
To conserve power, install the LED disabling jumper to the LED DIS jumper pins when the
i
LEDs are not being observed.
When LED DIS jumper pins are shorted for the first time, the STATUS LED flashes the
firmware version.
F01U087835 | 02 | 2008.10
Short Message Service (SMS)
Terminal Interface on a PC connected using a USB port
System Reference Guide
8 Signal Strength 1 (SS1) LED
9 Signal strength 2 (SS2) LED
10 Signal strength 2 (SS2) LED
11 Bus LED
12 SIM Cardholder
13 SIM Card In Cardholder (Door Open)
Easy Series
Bosch Security Systems, Inc.