Advertisement
TROUBLESHOOTING
Cassette deck amplifier
Symptom
Cause
Remedy
Power switch is on but
power does not turn on.
AC cord is unpiugged.
®
Plug power cord into wall socket.
No sound from speakers.
Volume is turned all the way down.
Speaker cords are disconnected.
Speaker cords are connected with viny! insu-
lation still an.
Your desired listening source is not selected
with FUNCTION button,
Connection cords are not connected or are
damaged.
e
Raise volume knob setting.
e
Connect speaker cords correctly.
*
Strip vinyl insulation from speaker wire tips
before connecting.
e
Select correct listening source
with FUNC-
TION button.
¢
Connect
correctly
or replace
with good
quality cords.
Sound from only one
speaker,
One of the speaker cords is disconnected or
damaged,
*
Connect correctly or replace with good
quality cord.
Screeching or howling
sound heard during mic
mixing.
Microphone angle is bad.
Microphone is too close to speaker.
Volume is too toud.
e
Change microphone angle.
@
Move microphone further away from speakers.
e
Reduce volume.
Cassette tape does not
move.
No sound heard from
cassette tape.
Deck is in pause mode.
Cassette inserted incorrectly.
The listening source
is not selected to TAPE
with FUNCTION button.
Playing unrecorded tape.
©
Put cassette properly in holder.
|
©
Select to TAPE.
@
Play a recorded tape.
Tape sounds unclear, not
loud enough.
=
Cannot record.
Dirty head.
@
Clean head.
Erasure prevention tabs are broken off,
Dirty head.
«
Apply adhesive tape over tab holes.
e
Clean head.
Cannot copy tape.
One deck has no cassette tape loaded.
Tape in Deck {1 has erasure
prevention tabs
broken off.
Load cassette tapes in both decks.
e
Use cassette that can be recorded on.
Treble tones unclear.
Dirty head.
DOLBY NR system is ON when listening to a
tape recorded without DOLBY NR.
2
Clean head.
e
Use same noise reduction system for play-
back as for recording. (Do not play tapes
recorded with different NR systems.)
Treble tones too strong.
Cassette tape recorded with DOLBY NR but
played without.
e
Play in same condition as recording. (Turn
on the DOLBY NR switch for recorded tapes
with DOLBY NR.)
Strange sounds heard {or
recorded from} tape, CD, or
radio.
TV is on.
This unit is too close to TV.
e@
Turn off TV.
Move TV away until interference stops.
e
Copy using NORMAL
instead
of HIGH
SPEED.
e
Music Search does not
work.
No 4-second space.
©
Use tape with
4-second
space
between
songs.
CD Auto Function does not
work,
Fiat cable not connected.
e@
Securely connect flat cable.
29
<ARB1410>
En
Advertisement
