GE
D
5573152-100, R
IRECTION
8-9-5-1
HDD - BEP6.x removal
If the HDD has patient data, leave the HDD at the site.
Table 8-141 HDD - BEP6.x removal
1.
Loosen the thumb screws or screws at the top of the BEP cover, or the three screws that attach
the cover to the BEP.
Tilt the top of the BEP cover away from the BEP.
2.
Disconnect the battery from PCN1 on the
the CB (ChargeBoard).
3.
Disconnect HDD Power cable (1) and
SATA cable (2).
NOTE: DO NOT forget to release the metal
tabs holding the cables to the Hard Drive.
Pulling the cables without releasing the tab
will damage to the cables.
8 - 226
. 2
EV
Steps
Section 8-9 - BEP (Back End Processor) parts replacement
LOGIQ E9 S
ERVICE
Corresponding Graphic
BEP6 CB cables
HDD cable connections
M
ANUAL