GE LOGIQ E9 Service Manual page 193

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

Monitor Arm Vertical adjustment - Ergotron Arm

If the Monitor is too loose or too tight when it is tilted, perform a Tilt adjustment.

Tilt the Monitor down and remove

the Monitor Rear Cover.

If you have a thick wrench, it is

easier to reach the nuts by using the

boxed end of the wrench.

If the Monitor is too loose, turn the

Adjustment Nut (A) towards the

back and Nut (B) towards the front

to increase the friction, using a

13 mm wrench.

Turn the Nuts the opposite direction

to decrease the friction. The Monitor

should stay in the position it is

released at.

NOTE: Be sure to tighten or loosen

both sides equally. Start with 1/4

turn and test full 90 degree

movement before tightening or

loosening more.

Reinstall the Monitor Rear Cover.

Monitor Tilt adjustment - Ergotron Arm

Chapter 6 Service Adjustments

Corresponding Graphic