Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha AG200FED 2012 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1
1. Remove the turn signal lens by
pushing it down lightly, then pulling
it outward.
2
TIP
The lens holder will fall out of the turn
3
signal when removing the lens, so take
care not to loose it.
4
5
6
7
1
8
1. Turn signal light lens
2. Turn signal light bulb
9
3. Lens holder
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
EAU24232 wise until it stops.
4. Install the holder, and then place
the lens in the original position.
3
2

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
7-31
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
EAU24350