Replacing The Brake/Tail Light Bulb; Replacing A Turn Signal Light Bulb - Yamaha AG200FEM 2021 Owner's Manual

Replacing the brake/tail light
bulb
1. Remove the brake/tail light lens by
removing the screws.
2
3
1. Screw
2. Brake/tail light lens
3. Brake/tail light bulb
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10682]
Periodic maintenance and adjustment
EAU70550
Replacing a turn signal light
bulb
1. Remove the turn signal lens by
pushing it down lightly, then pulling
it outward.
1
TIP
The lens holder will fall out of the turn
signal when removing the lens, so take
care not to loose it.
1. Turn signal light lens
2. Turn signal light bulb
3. Lens holder
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
EAU24233
3
2
1
7-31
push it in, and then turn it clock-
wise until it stops.
4. Install the holder, and then place
the lens in the original position.
1
2
3
4
5
6
7
8
9
10
11
12