Replacing The Tail/Brake Light Bulb; Replacing A Turn Signal Light Bulb - Yamaha AG200FEE 2014 Owner's Manual

5. Place a new bulb into position, and
then secure it with the headlight
bulb holder.
1
1. Headlight bulb
2. Headlight bulb holder
6. Install the headlight bulb holder by
turning it clockwise.
7. Install the bulb cover, and then
connect the headlight lead con-
nectors.
8. Install the headlight unit by install-
ing the bolt.
9. Have a Yamaha dealer adjust the
headlight beam if necessary.
PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing the tail/brake light
bulb
1. Remove the tail/brake light lens by
removing the screws.
2
2
3
1. Screw
2. Tail/brake light lens
3. Tail/brake light bulb
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
EAU24134
Replacing a turn signal light
bulb
1
TIP
The lens holder will fall out of the turn
signal when removing the lens, so take
care not to loose it.
1. Turn signal light lens
2. Turn signal light bulb
3. Lens holder
[ECA10682]
7-30
1. Remove the turn signal lens by
pushing it down lightly, then pulling
it outward.
2
1
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
EAU24233
1
2
3
4
5
6
7
3
8
9
10
11
12