Yamaha MT-10 2020 Owner's Manual page 26

Instrument and control functions
1
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
2
turn, push this switch to "
leased, the switch returns to the center
3
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
4
5
Horn switch " "
Press this switch to sound the horn.
6
Traction control system switch
7
"TCS"
See page 4-4 for an explanation of the
traction control system.
8
9
Stop/Run/Start switch "
To crank the engine with the starter, set
this switch to " ", and then push the
10
switch down towards " ". See page
7-1 for starting instructions prior to
11
starting the engine.
Set this switch to " " to stop the engine
12
in case of an emergency, such as when
the vehicle overturns or when the throt-
EAU66040 tle cable is stuck.
/ "
Hazard switch " "
". When re- With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
EAU66030
might be a traffic hazard.
NOTICE
EAU73961
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU66060
/ / "
Cruise control switches
See page 4-1 for an explanation of the
cruise control system.
"SELECT" switch
This switch is used to perform selec-
tions in the odometer, tripmeters, cool-
ant temperature and air temperature
display of the multi-function meter unit.
(See page 5-6.)
EAU66010
" posi- Drive mode switch "MODE"
See page 4-3 for an explanation of the
drive mode.
ECA10062
EAU73951
EAU73943
5-3
EAU73931