Maytag MEDE200XW Use And Care Manual page 11

Changing the Auto
Cycles Default Settings
IMPORTANT: Your dryness level settings can be adjusted to adapt
to different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your Auto
Cycles, not just the current cycle/load.
If all your loads on all Auto Cycles are consistently not as dry as
you would like, you may change the default settings to increase the
default dryness level. This change will affect all of your Auto Cycles.
There are 3 drying settings, which are displayed using the WET,
DAMP, and COOL DOWN indicators:
temperatures dryness level cycle signal
1. (factory preset dryness level) - WET indicator lit.
2. (slightly drier clothes, 15% more drying time) - WET and DAMP
indicators lit.
3. (much drier clothes, 30% more drying time) - WET, DAMP, and
COOL DOWN indicators lit.
To change the Dryness Level settings:
NOTE: The Dryness Level settings cannot be changed while the
dryer is running.
1. Press and hold the TEMPERATURES button for at least
6 seconds. The dryer will beep, and the current drying mode
will be displayed.
2. To select a new drying setting, press the TEMPERATURES
button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting
will be lit solid, but the other settings will flash.
3. Press the START/PAUSE button to save the drying setting and
exit to standby mode.
NOTE: To exit without saving, press the POWER/CANCEL
button.
4. The drying setting you selected will become your new preset
drying setting for all Auto Cycles.
11