Brother MFC-J680DW Basic User's Manual page 61

Error Message
Cannot Detect Ink
Volume
Cannot Print
Replace ink.
Connection Failed You tried to poll a fax machine that is not in Polled Waiting mode.
Data Remaining in
Memory
Disconnected
Document Jam/too
Long
DR Mode in Use
High Temperature
Hub is Unusable.
Image Too Long
(MFC-J880DW/
MFC-J885DW)
Image Too Small
(MFC-J880DW/
MFC-J885DW)
Action
Use a new Genuine Brother Innobella Ink Cartridge. If the error is not
cleared, call Brother Customer Service.
One or more of the ink cartridges have reached the end of their lives.
Replace the ink cartridges.
For more information, see the Online User's Guide: Replace the Ink
Cartridges.
• You can still scan even if the ink is low or needs to be
replaced.
Check the other fax machine's polling setup.
Press . The machine will cancel the job and clear it from the
memory. Try to print again.
Try to send or receive again.
If calls are stopped repeatedly and you are using a VoIP (Voice over
IP) system, try changing the Compatibility to Basic (for VoIP).
See Related Information: Telephone Line Interference/VoIP at the end
of this section.
The document was not inserted or fed correctly, or the document
scanned from the ADF was too long.
See Related Information: Document Jams at the end of this section.
The machine is in Distinctive Ring mode. You cannot change the
Receive Mode from Manual to another mode.
Set Distinctive Ring to Off.
For more information, see the Online User's Guide: Turn off Distinctive
Ring.
After cooling the room, allow the machine to cool down to room
temperature. Try again when the machine has cooled down.
Hubs, including a USB flash drive with a built in hub, are not
supported. Unplug the device from the USB direct interface.
The proportions of your photo are irregular so effects could not be
added.
Choose a regularly proportioned image.
The size of your photo is too small to trim.
Choose a larger image.
45