Advertisement
6. For the cleanest finish, follow up with the
foil shaver
7. For cutting hair without completely removing
it, attach the 5-position comb to the head. Place
the comb on the cutting blades first, and then
snap down on to the back of the trimmer head.
8. Start with the longest setting, by moving
the comb switch away from the back of the
trimmer.
9. Gently move the comb through the hair in
the direction of growth.
10. After you have done this with the longest
setting, if you want to make the hair shorter,
move to the next lowest position until the
desired length of hair is achieved.
11. After hair removal, run a comb or brush
through the hair to remove any cut loose hairs
12. When you have finished, move the switch
to the OFF position. Clean the blades with the
provided brush and then return the handle to
the charging base to ensure it is fully charged
for the next use.
13. If the blades become dull or damaged,
contact Conair Customer Service and order a
replacement blade set.
USING THE EYEBROW TRIMMER
1. Be sure the handle is fully charged
2. Attach the trimming head as described in
"Changing the Heads" section
3. To outline and shape your eyebrows, use
the trimmer without the attachment comb.
4. Move the power switch to the ON position.
5. Use the blades to define the edge of the
eyebrow.
6. Once the shape of your eyebrow has been
defined, you may thin out the hair using the
attachment comb.
7. Place the comb on the head in the longest
position by sliding the comb into the groove
on the head closest to the blades
8. Gently move the comb through the hair. If
you need to remove more hair, move the comb
to the shortest position, the groove furthest
away from the blades. If you want to remove
the hair completely, leave the comb off and
move the blades against the direction of
growth.
9. When finished, move the on/off switch to
the OFF position and clean the blades with the
supplied cleaning brush.
TO REPLACE THE
EYEBROW BLADES
1. Move the release switch on the side of the
eyebrow trimmer head.
2. Lift off the blade cover exposing the metal
blades inside.
3. Remove the blades, and replace them with
the new set.
4. Place the blade cover and slide the switch
back to its original position.
Advertisement
