Specktrum Dx2E Radio System; Installing The Transmitter Batteries - Team Losi 8ight mini Instruction Manual

sPektruM dX2e radIo systeM
9 10 11
6
5
4
7

INSTAllING THE TRANSMITTER BATTERIES

1. Push in the battery cover a small amount to release the retaining tab, then remove the cover.
2. Install 4 AA batteries, taking care to align the battery polarity to the diagram in the transmitter's
battery case.
3. Carefully reinstall the battery cover by aligning the tabs with the slots on the transmitter.
CAUTION: Do not remove the transmitter batteries while the model is powered
on or while operating, as a loss of model control, damage or injury can result.
For more information on the transmitter, go to www.horizonhobby.com and click
on the support tab for the Spektrum DX2E to download the instruction manual.
LOSI MInI 8IGHT-T RTR • InSTRucTIOn ManuaL LOSI MInI 8IGHT-T RTR • InSTRucTIOn ManuaL
3
8
1
2
12
13
14
15
16
17
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3. Antenna Transmits the signal to the model
4. ON/OFF Switch Turns the power ON/OFF for the transmitter
5. Indicator lights
- Solid green light—indicates adequate battery power
- Flashing green light—indicates the battery voltage is critically low. Replace batteries
6. ST Trim Adjusts the total steering travel
7. TH Trim Adjusts the total throttle travel
8. ST Rate Adjusts the sensitivity of AVC
9. BIND Button Puts the transmitter into Bind Mode
10. ST. REV Reverses the function of the steering when the wheel is turned left or right
11. TH. REV Reverses the function of the speed control when pulled back or pushed forward
SRS4200 AVC TECHNOlOGy RECEIVER
12. BIND
13. DISABlE
14. AUX 2
15. AUX 1
16. THR
17. STR
BIND/BATT
DISABLE
DATA
SRS4200
AUX2
AUX1
4CH SURFACE RECEIVER
THR
STR
EN EN
5 5